Three 10-ton Kone Cranes installed on a Lift supplied runway
system at a major Midwest paving equipment manufacturer.
.
A
fully-enclosed air-conditioned crane cab having seat mounted cab
master controls. This cab replaced an existing open cab in an
Upper-Midwest steel foundry.
This
is one of a pair of 5-ton cranes having the girder built on a 30
degree angle. The cranes ride on TC/American patented track and
feature two Coffing hoists, one @ 3-ton capacity, and one @ 2-ton
capacity.
A
crane and runway system having two side-by-side self supported
runways. Each runway has two @ 5-ton Kone cranes installed on
it. The crane system fits under a roof-supported crane system
that also uses Kone Cranes. This system is installed in Colorado.
This is a 195’
length Kone Cranes system with12 @ 7-ton hoists used to lift
complete barge cover sets so that the barge can be unloaded. The
crane rides on nine flexibly suspended TC/American patented track
runways using a positive gear-rack drive system. This system was
installed near New Orleans, LA.
This
25-ton crane system and runway system were supplied for machine
maintenance. The runway is a self standing system, with the crane
having all frequency drive controls for bridge, trolley, and
hoist.
This
is a 108’ span top running single girder crane installed in a
government vehicle test facility in Iowa.
A crane and
runway system Lift supplied to a physics research facility located
2400’ under the surface of the earth. The 7 ½-ton crane and
runway are hung right off of the rock walls of the cavern.
A
five @ 2-ton capacity crane and runway system installed over an
engine assembly line for a major Midwest paving equipment
manufacturer.
A
crane and runway system using three @ 2-ton capacity Kone Cranes
new CXT crane systems. The cranes ride on TC/American patented
track runways.
This
is a 195’ length Kone Cranes system with12 @ 7-ton hoists used to
lift complete barge cover sets so that the barge can be unloaded.
The crane rides on nine flexibly suspended TC/American patented
track runways using a positive gear-rack drive system. This
system was installed near New Orleans, LA.
TC/American
Spanmaster floor mounted light rail crane and runway systems for
work cell use.
These are two of ten cranes supplied to a transformer rebuild
facility in the upper Midwest. The crane in the foreground is a
25-ton crane with a built-up crane trolley, the crane in the
background is a 115/20-ton bridge crane.
A
crane and runway system having three @ 1-ton and one @ 3-ton Kone
cranes with Coffing electric chain hoists. The cranes and hoists
all use frequency drive controls. This system is installed in
Colorado.
